Our prices start at £1,100 per foot for a fully fitted narrowboat, or if you prefer to fit one out yourself we offer a range of narrowboat's and wide beam's completed to any stage.

Check out the price and spec below for a 30ft fully fitted narrowboat, a 57ft sail away narrowboat and a 57ft sail away widebeam.

Prices for other size narrowboat's and wide beam's are available on request.

We can also manufacture steel and stainless steel tanks for fresh water and waste.

Also we manufacture a range of hand made rope fenders.

Please feel free to contact us if you need more information and pricing.

Fully fitted 30ft Cruiser Stern Narrowboat. Ready to sail.

• Shell - 30ft narrowboat with cruiser stern. 8mm base plate, 6mm hull sides, 5mm cabin sides and 4mm roof. 22ft long cabin approx. Gas locker at rear. Quick release weed hatch. Integral keel cooler. Integral fuel tank. Mooring studs fore and aft. Side fender eyes. Roof ring. Integral hand rails on roof. Stern rail. Rudder + rudder stock + tiller bar. Steel rear door + sliding hatch to one side. No front deck to allow maximum cabin space. Steel half size glazed front doors
• Engine to suit.
• Sprayfoam insulation, 18mm ply floor with laminate flooring on top. Adequate ballast. 3 * mushroom vents, 6 x 18" portholes, Lined in ash/oak faced ply with hardwood trim + ash effect window liners all oiled with 5 coats of danish oil.
• 12v electrical system throughout with 240v sockets. 2 * marine leisure batteries with fuses and isolator switches. Tunnel light + horn.
• Water pump with Accumulator. All piping pressure tested.
• High quality two tone paint scheme with coach lines. Any colour you like. Roof, gunwales and decks painted in non-slip finish. Hull painted with 3 coats of quality hull blacking.
• Stainless Steel Water Tank (200 litres approx) with tank gauge.
• Gas – Space for a two gas bottles with single regulator, shut off valve.
• 30l Single coil calorifier with immersion heater + expansion tank.
• Victron Phoenix MultiPlus 1200w pure sine inverter/charger.

• Galley
  • Combination stainless steel sink + twin gas hob.
  • Small 12v fridge.
  • Small single gas oven + grill
  • Storage cupboards + work top
• Bathroom
  • Tiled cubicle shower
  • Thetford cassette toilet
  • Small wash basin
  • Storage cupboards.
• Saloon
  • Pipsqueak Multifuel Stove
  • U-Shaped seating with storage underneath – converts to double bed
  • Removable table
• Upholstery – seat cushions and porthole 'plugs'
• Full cruising set - 4 x side fenders, large button, v-bow + mooring ropes

All this for just £35,920 ex works.

57ft Cruiser Stern Narrowboat sail away.

• Shell – 57' x 6' 10" - 10/6/5/4 spec. 41' cabin space approx. Cruiser stern. Quick release weed hatch. Integral keel cooler. Integral fuel tank. Gas locker at front. Mooring studs fore and aft. Side fender eyes. Roof ring. Integral hand rails on roof. Stern rail. Rudder + rudder stock + swan neck. Steel rear doors + sliding hatch. Steel front doors and Steel side doors. Painted in primer and hull blacked.
• 4 x 1.5kg Anodes.
• 45hp Barrus Shanks engine – fitted and working including bilge pump and engine cover (hex board)
• Battening, Sprayfoam insulation, ballast, floor & mushroom vents (5).
• Windows – (6 x 36"x24" top hopper + 2 x 15" portholes)
• Stainless Steel Water Tank + sensor + water filler + vent (600 litres approx).
• Quality single colour paint scheme using 2k paint with coach lines. Roof, decks and gunwhales treated with non-slip sufrace.

All this for just £33,490 ex works.

57ft Cruiser Stern Widebeam sail away.

• Shell – 57' x 10' – 10/6/5/4 spec. 41' cabin space approx. Cruiser stern. Quick release weed hatch. Integral keel cooler. Integral fuel tank with filler and vent. Gas locker at front. Mooring studs fore and aft. Side fender eyes. Roof ring. Integral hand rails on roof. Stern rail. Rudder + rudder stock + swan neck. Steel rear doors + sliding hatch. Steel front doors & steel side doors. Painted in primer and hull blacked.
• 4 x 2.5kg Anodes.
• 50hp Barrus Shire engine– fitted and working including bilge pump and engine cover (hex board)
• Battening, Sprayfoam insulation, ballast, floor & mushroom vents (5).
• Windows – (6 x 36"x24" top hopper + 2 x 15" portholes)
• Stainless Steel Water Tank + sensor + water filler + vent (800 litres approx).
• Quality single colour paint scheme using 2k paint with coach lines. Roof, decks and gunwhales treated with non-slip sufrace.

All this for just £44,700 ex works.

All other sizes of boats catered for. Just contact us for a price.

All prices are subject to change due to the ever changing costs of materials.

STAGE PAYMENTS: To secure a build slot in our schedule we require a deposit of just £500.00. The Nottingham Narrowboat Company can either arrange complete package deals, including shell, engine and fit-out, or you can have us just do the fit-out and arrange the other services yourself. Where The Nottingham Narrowboat Company takes care of the complete package, the cost of the hull needs to be paid before it is delivered to our yard. We then take stage payments for the fitting out of the interior, usually split into three payments of approximately 30%, (payment dates to be agreed and or notified dependant on build time) and the final 10% on completion.

CERTIFICATES: All boats are built to EC Recreational Craft Directives (RCD) standards, and are issued with CE marking, a Declaration of Conformity and Boat Owners Manual. We also issue all new boats with a Boat Safety Certificate (even though these are not required until the boat is 4 years old) for total peace of mind.

SPECIFICATIONS: Before work starts we will produce a drawing showing layout and specification details, along with prices to form the basis of our contract. Within reason, variations in specification can usually be accommodated after work has started, but may involve added costs and time.

WARRANTY: After a brief trial period and final payment has been made, all work is covered by our warranty period of 12 months. Separate warranties apply to purchased appliances where applicable. Any problems that arise after this period we will still do our best to solve as we are keen to maintain the usual good customer relationship we built up during the build, however some costs may be incurred such as traveling time, new parts etc but we will endeavour to keep these as low as possible. Our reputation is paramount to us.